Kernel driver corsair-cpro

Supported devices:

  • Corsair Commander Pro

  • Corsair Commander Pro (1000D)

Author: Marius Zachmann

Description

This driver implements the sysfs interface for the Corsair Commander Pro. The Corsair Commander Pro is a USB device with 6 fan connectors, 4 temperature sensor connectors and 2 Corsair LED connectors. It can read the voltage levels on the SATA power connector.

Usage Notes

Since it is a USB device, hotswapping is possible. The device is autodetected.

Sysfs entries

in0_input

Voltage on SATA 12v

in1_input

Voltage on SATA 5v

in2_input

Voltage on SATA 3.3v

temp[1-4]_input

Temperature on connected temperature sensors

fan[1-6]_input

Connected fan rpm.

fan[1-6]_label

Shows fan type as detected by the device.

fan[1-6]_target

Sets fan speed target rpm. When reading, it reports the last value if it was set by the driver. Otherwise returns an error.

pwm[1-6]

Sets the fan speed. Values from 0-255. Can only be read if pwm was set directly.

Debugfs entries

firmware_version

Firmware version

bootloader_version

Bootloader version