# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) # Copyright (C) 2026 Ideas on Board Oy %YAML 1.2 --- $id: http://devicetree.org/schemas/media/i2c/sony,imx678.yaml# $schema: http://devicetree.org/meta-schemas/core.yaml# title: Sony IMX678 Sensor maintainers: - Jai Luthra description: Sony IMX678 diagonal 8.86 mm (Type 1/1.8) CMOS active pixel type solid-state image sensor with a square pixel array and 8.40M (3856x2180) effective pixels. allOf: - $ref: /schemas/media/video-interface-devices.yaml# properties: compatible: items: - enum: - sony,imx678-aamr - sony,imx678-aaqr - const: sony,imx678 description: The IMX678 sensor exists in a colour variant (IMX678-AAQR) and a mono variant (IMX678-AAMR). The variant-specific compatible describes the exact sensor variant, with the generic IMX678 compatible as a fallback. reg: maxItems: 1 clocks: description: | Input clock (INCK). Only the rates listed in the datasheet are supported: 13.5, 18, 24, 27, 36, 37.125, 72, and 74.25 MHz. maxItems: 1 avdd-supply: description: Analog power supply (3.3V) ovdd-supply: description: Interface power supply (1.8V) dvdd-supply: description: Digital power supply (1.1V) reset-gpios: description: Sensor RESETN (XCLR) GPIO maxItems: 1 port: $ref: /schemas/graph.yaml#/$defs/port-base additionalProperties: false properties: endpoint: $ref: /schemas/media/video-interfaces.yaml# unevaluatedProperties: false properties: data-lanes: oneOf: - items: - const: 1 - const: 2 - items: - const: 1 - const: 2 - const: 3 - const: 4 - items: - const: 1 - const: 2 - const: 3 - const: 4 - const: 5 - const: 6 - const: 7 - const: 8 required: - data-lanes - link-frequencies required: - endpoint required: - compatible - reg - clocks - avdd-supply - ovdd-supply - dvdd-supply - port unevaluatedProperties: false examples: - | #include i2c { #address-cells = <1>; #size-cells = <0>; camera@1a { compatible = "sony,imx678-aaqr", "sony,imx678"; reg = <0x1a>; clocks = <&imx678_clk>; avdd-supply = <&camera_avdd_3v3>; ovdd-supply = <&camera_ovdd_1v8>; dvdd-supply = <&camera_dvdd_1v1>; reset-gpios = <&gpio 0 GPIO_ACTIVE_LOW>; port { imx678: endpoint { remote-endpoint = <&cam>; data-lanes = <1 2 3 4>; link-frequencies = /bits/ 64 <720000000>; }; }; }; }; ...