What: /sys/class/leds//delay_on Date: Jun 2012 KernelVersion: 3.6 Contact: linux-leds@vger.kernel.org Description: Specifies for how many milliseconds the LED has to stay at LED_FULL brightness after it has been armed. Defaults to 100 ms. What: /sys/class/leds//delay_off Date: Jun 2012 KernelVersion: 3.6 Contact: linux-leds@vger.kernel.org Description: Specifies for how many milliseconds the LED has to stay at LED_OFF brightness after it has been armed. Defaults to 100 ms. What: /sys/class/leds//invert Date: Jun 2012 KernelVersion: 3.6 Contact: linux-leds@vger.kernel.org Description: Reverse the blink logic. If set to 0 (default) blink on for delay_on ms, then blink off for delay_off ms, leaving the LED normally off. If set to 1, blink off for delay_off ms, then blink on for delay_on ms, leaving the LED normally on. Setting this value also immediately changes the LED state. What: /sys/class/leds//shot Date: Jun 2012 KernelVersion: 3.6 Contact: linux-leds@vger.kernel.org Description: Write any non-empty string to signal an events, this starts a blink sequence if not already running.