menu "Kernel hacking" source "lib/Kconfig.debug" config SH_STANDARD_BIOS bool "Use LinuxSH standard BIOS" help Say Y here if your target has the gdb-sh-stub package from www.m17n.org (or any conforming standard LinuxSH BIOS) in FLASH or EPROM. The kernel will use standard BIOS calls during boot for various housekeeping tasks (including calls to read and write characters to a system console, get a MAC address from an on-board Ethernet interface, and shut down the hardware). Note this does not work with machines with an existing operating system in mask ROM and no flash (WindowsCE machines fall in this category). If unsure, say N. config EARLY_SCIF_CONSOLE bool "Use early SCIF console" depends on CPU_SH4 || CPU_SH2A && !SH_STANDARD_BIOS config EARLY_PRINTK bool "Early printk support" depends on SH_STANDARD_BIOS || EARLY_SCIF_CONSOLE help Say Y here to redirect kernel printk messages to the serial port used by the SH-IPL bootloader, starting very early in the boot process and ending when the kernel's serial console is initialised. This option is only useful porting the kernel to a new machine, when the kernel may crash or hang before the serial console is initialised. If unsure, say N. config KGDB bool "Include KGDB kernel debugger" select FRAME_POINTER help Include in-kernel hooks for kgdb, the Linux kernel source level debugger. See for more information. Unless you are intending to debug the kernel, say N here. menu "KGDB configuration options" depends on KGDB config MORE_COMPILE_OPTIONS bool "Add any additional compile options" help If you want to add additional CFLAGS to the kernel build, enable this option and then enter what you would like to add in the next question. Note however that -g is already appended with the selection of KGDB. config COMPILE_OPTIONS string "Additional compile arguments" depends on MORE_COMPILE_OPTIONS config KGDB_NMI bool "Enter KGDB on NMI" default n config KGDB_THREAD bool "Include KGDB thread support" default y config SH_KGDB_CONSOLE bool "Console messages through GDB" default n config KGDB_SYSRQ bool "Allow SysRq 'G' to enter KGDB" default y config KGDB_KERNEL_ASSERTS bool "Include KGDB kernel assertions" default n comment "Serial port setup" config KGDB_DEFPORT int "Port number (ttySCn)" default "1" config KGDB_DEFBAUD int "Baud rate" default "115200" choice prompt "Parity" depends on KGDB default KGDB_DEFPARITY_N config KGDB_DEFPARITY_N bool "None" config KGDB_DEFPARITY_E bool "Even" config KGDB_DEFPARITY_O bool "Odd" endchoice choice prompt "Data bits" depends on KGDB default KGDB_DEFBITS_8 config KGDB_DEFBITS_8 bool "8" config KGDB_DEFBITS_7 bool "7" endchoice endmenu endmenu