From: Johannes Stezenbach updated documentation (Manu Abraham) Signed-off-by: Johannes Stezenbach Signed-off-by: Andrew Morton --- Documentation/dvb/bt8xx.txt | 41 ++++++++++++++++------------------------- 1 files changed, 16 insertions(+), 25 deletions(-) diff -puN Documentation/dvb/bt8xx.txt~dvb-bt8xx-updated-documentation Documentation/dvb/bt8xx.txt --- 25/Documentation/dvb/bt8xx.txt~dvb-bt8xx-updated-documentation 2005-05-09 18:01:37.000000000 -0700 +++ 25-akpm/Documentation/dvb/bt8xx.txt 2005-05-09 18:01:37.000000000 -0700 @@ -35,45 +35,35 @@ TwinHan (dst) are loaded automatically b $ modprobe bttv (normally bttv is being loaded automatically by kmod) $ modprobe dvb-bt8xx (or just place dvb-bt8xx in /etc/modules for automatic loading) -3b) TwinHan ------------ + +3b) TwinHan and Clones +-------------------------- $ modprobe bttv i2c_hw=1 card=0x71 $ modprobe dvb-bt8xx $ modprobe dst -The value 0x71 will override the PCI type detection for dvb-bt8xx, which -is necessary for TwinHan cards.# - -If you're having an older card (blue color circuit) and card=0x71 locks your -machine, try using 0x68, too. If that does not work, ask on the DVB mailing list. +The value 0x71 will override the PCI type detection for dvb-bt8xx, +which is necessary for TwinHan cards. -The DST module takes a couple of useful parameters, in case the -dst drivers fails to detect your type of card correctly. +If you're having an older card (blue color circuit) and card=0x71 locks +your machine, try using 0x68, too. If that does not work, ask on the +mailing list. -dst_type takes values 0 (satellite), 1 (terrestial TV), 2 (cable). +The DST module takes a couple of useful parameters. -dst_type_flags takes bit combined values: -1 = new tuner type packets. You can use this if your card is detected - and you have debug and you continually see the tuner packets not - working (make sure not a basic problem like dish alignment etc.) +verbose takes values 0 to 5. These values control the verbosity level. -2 = TS 204. If your card tunes OK, but the picture is terrible, seemingly - breaking up in one half continually, and crc fails a lot, then - this is worth a try (or trying to turn off) +debug takes values 0 and 1. You can either disable or enable debugging. -4 = has symdiv. Some cards, mostly without new tuner packets, require - a symbol division algorithm. Doesn't apply to terrestial TV. +dst_addons takes values 0 and 0x20. A value of 0 means it is a FTA card. +0x20 means it has a Conditional Access slot. -You can also specify a value to have the autodetected values turned off -(e.g. 0). The autodected values are determined bythe cards 'response +The autodected values are determined bythe cards 'response string' which you can see in your logs e.g. -dst_check_ci: recognize DST-MOT - -or +dst_get_device_id: Recognise [DSTMCI] -dst_check_ci: unable to recognize DSTXCI or STXCI -- -Authors: Richard Walker, Jamie Honan, Michael Hunold +Authors: Richard Walker, Jamie Honan, Michael Hunold, Manu Abraham _